Super Duplicate Remote Controls from ZDURC

Universal Duplicate Remote
Note:
This product can copy the remote control with the following chip inside: 2260(all manufacturers); 2262(All manufacturers); PT2264, 5326(All manufacturers);SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918 series, 527(All manufacturers); 1527(All manufacturers); 2240(All manufacturers); HCS101, HCS200\HCS201(part code), HCS300\HCS301(part code), part single chip microcomputer.

If you fail in copying with proper operation, you might have to check whether your device has a chip above.

Any question pls contact with me at email aimee@zdremote.com

How to Program:
Copy / Clone Instructions - 2 Easy Steps
The rolling code duplicator with high compatibility, can copy all fix code, learning code and part of rolling code. Before ordering, pls make sure your chip No. is within our IC compatibility list.
Our duplicator can be easily programmed by the following 2 setps.

Step 1 – Clear code
To clear factory preset codes used for testing purpose, you need do as follow
1 Press and hold the top two buttons (1st button and 2nd button) at the same time continuously until LED flash 3 times and off.
2 Only release 2nd(B)button and keep pressing 1st(A)button  ,and press 2dn(B)button slowly repeat for 3 times ,then the LED light will flash very fast.
3 Release 1st(A) button,finish code clearance

Step 2 – Copy(clone)
1 Place the original remote control and copy remote close together (<10mm as close as possible). 
2 Press and hold one button on your original remote and the button on copy remote which you wish to be programmed on at the same time for 
approximately 3 seconds, then LED indicator flashes two times,followed 
by a continuous fast blinking, indicating that the button is successfully copied.
3 Release both buttons,finish code copy. Repeat the above clone step for 
other buttons.